The rubber Tormach protective cover seems to do a decent job of protecting the back Y-axis bellows. Has anyone installed protective covers on the Y-axis in front of the table or on the Z-axis?
Printable View
The rubber Tormach protective cover seems to do a decent job of protecting the back Y-axis bellows. Has anyone installed protective covers on the Y-axis in front of the table or on the Z-axis?
Tormach PCNC 1100 - Neoprene Chip Guards (Darth Vader Conversion) - YouTube
Here is one persons attempt.
Quote:
Originally Posted by kstrauss
haha yeah, Chris bought that from me, lol
It's true! I've made a few small modifications to it since I installed it (like the time I ripped the Z bellows cover off with the vise while going through my machine warm up cycle), but it remains almost exactly the same. It's a good setup that makes clean up a breeze, and most importantly, prevents the Y bellows covers from getting damaged by motion to the extreme limits when chips are packed into the ribs of the bellows.Quote:
Originally Posted by BAMCNC.COM
I just have mine wedged in between the bellow "braket" and then screw the below screws in, so it pinches it. It comes undone once and a while. I'm to lazy to get back there and tap some holes.