In this video I show how to program a 3D chamfer using morph between 2 curves.
http://youtu.be/SKFso-3LPS4
Printable View
In this video I show how to program a 3D chamfer using morph between 2 curves.
http://youtu.be/SKFso-3LPS4
This video was very helpful for me. I've been using project curves with a straight endmill to calculate the feature, then changing the tool to my chamfer bit. Then I had to run the simulation to see if it was cutting to the proper chamfer depth, and make adjustments as needed. I just tried this feature out on a part I ran last week, and saved the feature.