Printable View
Hello Guys
I have problem when i want to generate 5axis G-code alarm occurs see on the picture below.
The machine is DMU 50evo.
This happened only when i want to generate 5axis simultaneous G-code,with 3axis and 3+2 axis i haven't problems.
Any ideas?
Mybe a postprosessor problem.
In the Machine Control tab set "Machine Limits" to "'No limits'. However, if your vmid file and MachSim truly reflect the kinematics and axis limits of your machine you may find that the machine alarms out when you run the code. Also you may need to use the alternative angle pair if the CAM job is taking your tilt axis the 'wrong' way.
In the Machine Control tab set "Machine Limits" to "'No limits'. However, if your vmid file and MachSim truly reflect the kinematics and axis limits of your machine you may find that the machine alarms out when you run the code. Also you may need to use the alternative angle pair if the CAM job is taking your tilt axis the 'wrong' way.
I try but the same alarm occurs.Any other idea?
As I said, check your MachSim model and the vmid file. There may be a discrepancy between them. Also, there may be an issue with your post processor that is related to the vmid file.