Having problems with spindle speed set to 0

trying to run an engraving program for the first time using a diamond drag. The spindle should be turned off for this so I put S=0 ....trying to run this on a Haas TM1P if that matters....

this is the program:

%
O4811 (MC blades logo engravingtest)
N1G40G49G80
(Engraving)
N2(Tool Diameter = 0 Length = 90 )
N3G21T10M6
N4 S0M3
N5G90G0X95.758Y-14.284G54
N6G43Z10.H10
N7G54
N8 G1Z-3. F100.
N9 G17
N10 G03X90.758I-2.5J0. F200.
N11 X95.758I2.5J0.
N12 G0Z10.
N13G00 G91 G28 Z0.
N14G28 Y0.
N15M30
%


Just trying to engrave a small circle as a test...however I get the error message :

"Range error" with the cursor on line N4

Any ideas to solve this?

thganks in advance!

Why select M3 at all? You did want the motor stopped. Just comment out or delete N4 block (not a line. A block, they are called)

c