Tools library

Been putting some time into sprutcam setups again.
I have a complete selection of tools, holders and overhangs setup to help spot potential problems better in multi axis and tombstone operations.
I would like to extend this utility a little more by setting up and using materials section of library also.
Anyone know where I can find more info or examples of use?
How does material library link to mill tool library?
Can feeds, speeds, woc and doc be set based on material and tool using equations?
Can tool list be filtered based on material of part?

Thanks in advance for any insight , help, tips or comments.
md

ps: I searched here and sprut forums and found little to no information, maybe im searching with wrong terms or in the wrong places