Printable View
From the controller [Fanuc 21i-T], I would like to view parameters #5131 & 5132.
When I go into the System/parameter page, the parameters stop at 4150 [or around there] and start again at 6000.
Does anyone know how to view the 5000 parameters on this controller?
Thanks for any help you can offer!
Not sure why these are not visible, but an easy way view them is to transfer them to an unused # parameter.
#100=#5131
#101=#5132
Give it a try!
Didn't think of doing that!
[doh~]
THANK YOU!
those parameters are some of the settings for the canned cycles. perhaps your machine has some other screen to configure that via a MTB-added screen.
Otherwise, the easiest way is just punch out all of the parameters to a PC via RS232 then look at the resulting text file and you can see everything.
If you can't see them but need to change them you could probably use G10
Thank you!
The parameters are part of the G71 canned cycle.
I don't want to change the settings, I just wanted to see what they were at before I ran a different configuration of the program. I needed to 'show' them to someone else to end a disagreement.