Ball Screw Bearing support
My company is having a Ball Screw repair/Replace done for our Takahashi TNC-L1 microstar. I was wondering if the Ball screw support bearings HAVE to be precision bearings (BS 20/47 7P62UF) or would it be fine to just match the bore diameter etc.. to the existing housing.
Re: Ball Screw Bearing support
Hi,
the locating bearing at the drive side?
This bearing needs to be precise and stiff - or the machine itself will not be precise and stiff.
So yes - it needs to be a precision bearing even though they often cost a little fortune.
Christian
Re: Ball Screw Bearing support
the bearings must be from P4 or P5 class of precision and the ballscrew must be pretension after replacing the bearings for a good accuracy during machining.