1 Attachment(s)
hurco hawk spindle drive problems
Hi all
I was running my hurco hawk with no problems then when asked to in the program
changed it to low gear for reaming.Then error popped up.Spindle drive overload,reset servo drives or spindle drive.
They would reset but as soon as I pressed power on.Same thing Happened.
attached picture shows what comes up.The leds come on with these codes then power is lost on all servo packs
Any help would be greatful
Attachment 251550
Cheers Neal
Re: hurco hawk spindle drive problems
EPROM is corrupted or the CPU is faulty in the drive. You can copy all the parameters out of the drive and then re-initialise it to see if it is corruption and bring it back from the dead or if it needs a new CPU.
Re: hurco hawk spindle drive problems
Thanks Mr Bloke
Is this something easy-ish to to with a bit of research or is it a call to an hurco engineer
Thanks again Neal
Re: hurco hawk spindle drive problems
It's not too tricky to do. It's a while since I've loaded parameters into one of those drives but they are easy enough to do. Where are you in blighty?