Doosan MYNX 6500 programing question

We got a Doosan MYNX 6500/50 with a Fanuc i controller. I'm trying to drill a series of holes using G-code. What ive got is a can cycle followed by a G91 x1.0 L11 When I do this on my mori or haas it will incrementally move over 1" 11 times but when I do it on the MYNX it does the fist hole moves over 1" does the 2nd hole then ends the program. Am I missing something here? I tried to read the FANUC manual but that confused me even more. Im posting it on the Doosan page in case it has to do with a parameter.

I'm assuming it's a 0iM-D? Use a K11 instead of the L11.

Dave is correct. The "K" word has replaced "L". Should work like a champ.

Thanks. That worked.