Combining peck drilling cycle with deep hole peck

I am using EIA (G code) programming on Mazak mills and wanting to put a small peck in a deep hole (G83) drilling cycle. Ive found a couple of suggestions using different letters in the cycle but none seem to work on this machine. Any help is greatly appreciated

Quote:

---

Originally Posted by adams4182

I am using EIA (G code) programming on Mazak mills and wanting to put a small peck in a deep hole (G83) drilling cycle. Ive found a couple of suggestions using different letters in the cycle but none seem to work on this machine. Any help is greatly appreciated

---

Hi,

Which control ?
Do you have some lines of nc-code (example).

Regards,
Heavy_Metal
The Netherlands.

Controller is M Plus. G83 RZQF. Would like a small peck to break a chip before it makes a full retract out of hole

Hi,

There is a risk that chips leave behind in the hole. Why don't you change Q.
You can write the code for the Z-moves in a sub-program or macro.
Whit the G73/G83 parameter N0.532 (Fanuc 0M), 5114/5115(Fanuc 21M) you can change some values but not what you want.

Regards,
Heavy_Metal
The Netherlands.