Printable View
Hello,
I have made my own 3-axis engraving machine from scratch and have everything running well, but I need help with the Z-axis setup. I have only used the ports/pins and the homing/limits to set the direction and homing. I want to set z-axis home to the up position but the co-ordinates are working in reverse. How do I setup the z-axis ?.
Cheers,
Brett.
Do you want to reverse the direction it's moving? If so, check "Reverse" in the Homing/Limits page.
Hi Gerry,
Zeroing the z-axis to the bottom switch would seem the way to go, but when I have a tool in the spindle it will hit the machine table before the bottom limit switch !. My problem is more about how the z-axis needs to be setup more than how to reverse settings.
Cheers,
Brett.
Typically you home the Z to the top of it's travel, and zero it to the surface of the part before running your programs. You might want to look into making an Auto Zero device.
http://www.cnczone.com/forums/showthread.php?t=36099
HI THERE CAN ANYBODY HELP ME
MY MACHINE WILL HOME THE X AND Y AXIS BUT I RECENTLY PUT A SWITCH ON THE TOP OF Z AXIS AND IT WILL NOT HOME, WONT DO ANYTHING AND THEY ARE ALL WIRED THE THE SAME THE OTHER 2 HOME PERFECTLY
I AM USING MACH 3
DARREN