Dear community,
my old (1987) lathe Fanuc ot ,while it was being in stendby, appeared an error in a video: Servo allarm: 02 (VRDY OFF)
I have tried to reset but not whork.
In Servo Drive (A06B-6047-H202) the allarm is Hcal on a L series.
I have checked the power Drive 18V 0V 18V and it's ok.
I have checked the cable but it's ok.
If I reset, the power clutch under servo drive tries to give power, but it's
desengage.
Help me...............
