Mori SL3 with Fanuc 6T control, need help

Hi folks,

I'm in the process of getting my SL3 running. I purchased the machine in an un-operating condition and have it almost going (I think). Yesterday, I got the control to come up after replacing the control power supply. It had been damaged by a shorted proximity switch in the tool turret. I'm currently working through replacing/troubleshooting these switches and have the 24v source to these switches disconnected while I troubleshoot them.

The control now comes up and states "NOT READY" but all of the parameters, pages, etc. on the control appear to be intact. The operator panel shows an error LED, which I think points to the spindle. There is also an alarm message: O0010 N0010. I'm not sure if the 0010 is an actual alarm since alarm 10 seems to be simply an invalid program and there aren't any programs currently loaded.

At this point, I'd just like to know if anyone has this same machine and control and could give me some insight on whether the screens and error LED I currently have are normal, or if you know where I should be looking next. I'll post some photos of the screens from my phone next.

Thanks in advance for any input you can give.

Ryan