good set up?

mechanical
5x10
acme screw on gantry
rack and pinion on x
zap series z with swap out plate for 3hp techno motor(later)
rollon compac 63mm rail and trucks
gantry made out of 3x3 80/20

electronics
viper servo 4 pole servo
g320x drive
breakout board?
smoothstepper
proma torch height controller

plasma
hypertherm 45

water table
custom pan
2 55 gallon barrels
same set up as desert fab works

extras
putting pallet racking over plasma table extending 6 foot past table weld it together and make gantry crane along rails for loading or unloading

how it will be used
im a college student that is selling a lot of random product from 3/16 to 18 gauge and im spending on average $200 a week paying a freind to use his cnc plasma the sooner the better and im planning on putting about 20 hours a week on it when its done. eventually i would like to use it as a cnc router to make chuck boxes out of my own milled oak slabs.