My New/Old Anilam Crusader M has a problem

Hi everyone!

I bought an old (1986) mill equip with a Crusader M control that I was planning on retro fitting however the control does power up but the diagnostic tests show a 'DUART failed'. Is this fatal as in it's cheaper or easier to replace the control or is it an easy fix?

Any help would be appreciated!

LaVerne

Time for a new control. Even if you solve this one, it will just go down again. Today's hobby controls are light years better than the professional controls of 20 years ago.

Karl

Sorry gents. The uart was a brain fart on Anilam's part. It was to be for future use. The control doesn't have it installed.

Good luck - I still use my M.