Lifting an 86 QT10N

hi guys,

Is it acceptable practice (not going to stuff the machine) if I have it lifted from underneath with a fork lift?

This is the recommended lifting method (from the manual)

https://lh3.googleusercontent.com/-H...627_133420.jpg

but the problem is that anything that i get to lift it in that configuration is going to make it way too tall to get into my shed.

I've seen a lot of photo's of people lifting CNC machines from the bottom with a fork and it sits on it's base on the ground, so i assume it is alright?

Cheers,
Trav

No problem lifting with forklift close to floor but much safer to lift with slings off truck.