8055 and pre-selecting the tool
Hi everyone. This could be very simple question but; how do i pre-select next tool with machining centre? If I put T6 twice to the program, the magazin starts spinning around and I need to reboot the machine. Only rebooting stops magazine.
If i put only one T6 just before M6, the machine has to wait until next tool is on the right position. If the T6 is couple of lines up, and I have to stop program for some reason, continuing is rather difficult.
Is there some kind of call that the machine keeps looking code forward or how should it be?
like this:
...
G1 X150
T6 ; pre-select here for example
Y60
X0
G0 Z3
M5 M9
T6 ; Magazine starts spinning around becouse of second T6-call
M6
G0....etc..
....
(Hope that somebody understood what I'm asking for. :o )