Re: Finish toolpath issues
You could try posting on the Vectric Web site here: Vectric Forum ? Index page There are a lot of helpful people there.
I am not sure why it would split the cutting area. Its really hard to tell without being able to look at the project and seeing the machining paths and vectors you used.
Mike
2 Attachment(s)
Re: Finish toolpath issues
I thought it would be the obvious forum to start also... I am waiting for administrative approval.
The entire file is too big to load here. I cleared everything except the area I am asking for help with.
Image plus zipped crv3d file.
Attachment 250770
Re: Finish toolpath issues
I have installed the 4.5 update. I was hopeful it would solve the issue. But it is not really a pocket path...
Quote:
Creating a pocket toolpath on slots or "donut" type pockets which are the same width as the tool would often cause undesirable results in previous versions of the software. This has now been updated to automatically recognize this situation and whenever possible try to machine these parts in a single pass making a more efficient toolpath with a better finish.
Re: Finish toolpath issues