Superspacer 4th axis loses steps when gong slow.

I have a 6" superspacer (P/N 34123) 4th axis. When it's rotating slowly, it's losing steps. I think stepper motors have less power when moving in partial-step increments. Any ideas how to remedy this? Are there driver setting or something?

I figured it out. The DIP switches on the driver board were on the wrong setting..

Quote:

---

Originally Posted by scott216

I have a 6" superspacer (P/N 34123) 4th axis. When it's rotating slowly, it's losing steps. I think stepper motors have less power when moving in partial-step increments. Any ideas how to remedy this? Are there driver setting or something?slope game

---

If you have access to the driver settings, you may want to consider increasing the current or adjusting other parameters to provide more power to the motor during partial-step movements.