I wish I could but I know nothing about G codes..
I do not use G codes in my program.. Everything my program does is hard-coded with my own code writing.
If you post the code, I might be able to give you some help but as I said, my machine is NOT a typical CNC machining center.
I only use CNC controls to operate my machine/process but it has nothing to do with actual machining.
If you post the code, I might be able (should be able) to give you an idea of what is going on with it.
I wish I could be more helpful..
Also, just so you know, you got lucky I saw your post because I do not log into this forum as often. Most, if not all, of my problems have been solved and my learning curve is pretty much flat at this point so I dont use the forum so much anymore. Knowing you are looking for help, I will check back shortly to see if I can assist you.
Murphy
Thanks for the offer Murph
Murphy625,
I am still having a hard time getting a grasp of this variable thing. I sure would appreciate your take on it, even if it doesnt directly apply to my 3 axis Bridgeport.
Thanks Again,
Plateroomred