I got a message saying "Radius at end of are different from radius to the start line 237.
What the hell? The part looked kinda like a cloud. Not exactly challenging.
I got a message saying "Radius at end of are different from radius to the start line 237.
What the hell? The part looked kinda like a cloud. Not exactly challenging.
Try changing your IJ mode in Mach3 General Config.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Then make sure that CamBam is outputting arcs in the format that your version of Mach3 is expecting.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
They can do that to Mach3???Its a Tormach and they have a habit of locking out any configs that change the program in their version.
Are they locking the XML somehow?
Cheers
Roger