585,712 active members*
3,920 visitors online*
Register for free
Login
IndustryArena Forum > CAM Software > SolidCAM for SolidWorks and SolidCAM for Inventor > I'm looking for a SolidCAM post processor for a Hurco TMM10?

Thread: I'm looking for a SolidCAM post processor for a Hurco TMM10?

Results 1 to 3 of 3
  1. 06-19-2012, 01:55 PM #1
    Skin
    Skin is offline Registered
    Send a message via MSN to Skin
    Join Date
    Nov 2005
    Posts
    48

    I'm looking for a SolidCAM post processor for a Hurco TMM10?

    SolidCAM say that there isn't a post processor for the TMM10 Mill turn, no WinMAX generic Mill Turn lathes...

    Is this so? Is there no one out there with a Hurco Mill Turn that uses SolidCAM?

    I'm not looking to use your post processor, I want to tell SolidCAM that I don't want to pay £1000 for them to come out and write me a post processor?

    CADMunkie
    Reply With Quote Reply With Quote
  2. 06-07-2013, 09:52 AM #2
    drys52
    drys52 is offline Registered
    Join Date
    May 2013
    Posts
    0
    Hi CADMunkie,

    We can supply a "generic" Post Processor for your Hurco no problem for a nominal cost, however we would always strongly recommend an engineer visiting site to configure the Post for your individual requirements. Obviously this is where the charges come into effect, but you end up with a Post 100% of what you need whereas a generic Post may not give you the very best output. Please email me at [email protected]
    Reply With Quote Reply With Quote
  3. 04-18-2014, 06:35 PM #3
    solidcamx
    solidcamx is offline Registered
    Join Date
    Feb 2011
    Posts
    252

    Re: I'm looking for a SolidCAM post processor for a Hurco TMM10?

    hi,
    If you need a postprocessor, contact me at
    [email protected]
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Post processor for 5axis solidcam
    By zarif in forum SolidCAM for SolidWorks and SolidCAM for Inventor
    Replies: 9
    Last Post: 02-15-2015, 08:24 PM
  2. I need solidcam Siemens Post processor
    By eldahan in forum SolidCAM for SolidWorks and SolidCAM for Inventor
    Replies: 3
    Last Post: 08-29-2014, 01:13 PM
  3. engraving on OD Hurco TMM10
    By DLIDGEY80 in forum Uncategorised MetalWorking Machines
    Replies: 0
    Last Post: 07-13-2012, 09:52 PM
  4. Solidcam Hurco post
    By oldjag in forum SolidCAM for SolidWorks and SolidCAM for Inventor
    Replies: 7
    Last Post: 12-07-2011, 12:06 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules