584,841 active members*
4,264 visitors online*
Register for free
Login
IndustryArena Forum > MetalWorking Machines > HURCO > hurco hawk spindle drive problems
Results 1 to 4 of 4
  1. #1
    Join Date
    Sep 2005
    Posts
    26

    hurco hawk spindle drive problems

    Hi all
    I was running my hurco hawk with no problems then when asked to in the program
    changed it to low gear for reaming.Then error popped up.Spindle drive overload,reset servo drives or spindle drive.
    They would reset but as soon as I pressed power on.Same thing Happened.
    attached picture shows what comes up.The leds come on with these codes then power is lost on all servo packs
    Any help would be greatful

    Attachment 251550



    Cheers Neal

  2. #2
    Join Date
    Jun 2008
    Posts
    1103

    Re: hurco hawk spindle drive problems

    EPROM is corrupted or the CPU is faulty in the drive. You can copy all the parameters out of the drive and then re-initialise it to see if it is corruption and bring it back from the dead or if it needs a new CPU.

  3. #3
    Join Date
    Sep 2005
    Posts
    26

    Re: hurco hawk spindle drive problems

    Thanks Mr Bloke
    Is this something easy-ish to to with a bit of research or is it a call to an hurco engineer
    Thanks again Neal

  4. #4
    Join Date
    Jun 2008
    Posts
    1103

    Re: hurco hawk spindle drive problems

    It's not too tricky to do. It's a while since I've loaded parameters into one of those drives but they are easy enough to do. Where are you in blighty?

Similar Threads

  1. Hurco BMC25 Spindle Drive Problems
    By James_c in forum Fanuc
    Replies: 0
    Last Post: 01-01-2014, 04:23 PM
  2. Hurco bmc25 spindle drive
    By James_c in forum HURCO
    Replies: 3
    Last Post: 03-22-2013, 12:57 PM
  3. HUrco BMC 30 spindle drive
    By xclr82xtc in forum Uncategorised MetalWorking Machines
    Replies: 1
    Last Post: 07-10-2010, 07:04 PM
  4. Hurco Yaskawa axis drive problems
    By bezelchuck in forum HURCO
    Replies: 2
    Last Post: 04-09-2010, 08:02 PM
  5. Problems with Hurco VMX 30 High speed spindle
    By csjtcooky in forum HURCO
    Replies: 1
    Last Post: 12-03-2007, 03:16 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •