[leftcoastlefty]

New to Surfcam, experienced in Mastercam, just getting my feet wet playing with the Demo. I cannot seem to figure out how to get a pocket toolpath to start at a selected point. I can't find anything in the tutorials, but maybe I didn't look hard enough. Can anyone here point me in the right direction?

Thanks in advance.

[moldcore]

Before or after you select the geometry you can select the plunge location using the "Plunge" tab.

[leftcoastlefty]

Thanks moldcore! I actually figured it out at about 11 last night. Nice to know one can get help here.