[Dezmond]

Hey Everyone.

I purchased a set of 4 NEMA 42's from Automation Technologies and a breakout board from China.

I am trying to figure out how to wire it up to the drivers. I can't figure out Pulse, Dir, etc. hook ups to the board.

I hope you guys can help me with this.

Here is a photo of what I am trying to hook up.

Also here is the manual for the breakout board.

Thanks for any help in advance

Dezi

[IN-WondeR]

I must admit, the breakout board is far from the same quality as the drives and motors...

But your motor outputs from your BOB need to be connected to PUL +- and DIR+-. How exactly they need to be connected should be explained in any documentation you recieved with your BOB.

Your motors are connected to the drives on the drives A+- and B+-

And your drives should be connected to AC on the AC input in the bottom.

[victorofga]

theres a chart in the pdf...
example P6 = X step

first photos shows P locations, and numbers

from chart match them >>>>>> page 5

just make first a layout and organize the part.. then draw where wires are running..then you will make it easy...