If I were to connect my scope across the armature of my servo motors, what waveshape would I see? These servos are being driven by Gecko 320 drivers.. This might help to learn why I cannot make the Mach3 self calibration work..CNCBAILEY
Thread: Gecko 320 Output Waveshape
Results 1 to 1 of 1
-
08-21-2014, 02:22 AM #1
Registered
- Join Date
- Aug 2014
- Posts
- 2
Gecko 320 Output Waveshape
Reply With QuoteSimilar Threads
-
Gecko g540 Outputs Don't Output
By M Kiser in forum Gecko DrivesReplies: 19Last Post: 02-20-2014, 04:37 AM -
Gecko G540 + Mach3. Sometimes Gecko will freeze for no reason, no errors.
By carmamir in forum Gecko DrivesReplies: 1Last Post: 01-03-2014, 08:58 AM -
Gecko G540 A Axis has no output.
By magicman68 in forum Community Club HouseReplies: 2Last Post: 10-14-2013, 08:48 PM -
CNCrouterparts Gecko kit vs Keling Gecko kit
By mamexp in forum DIY CNC Router Table MachinesReplies: 11Last Post: 03-03-2012, 11:30 PM -
To Gecko, or not to Gecko...that is the question!
By samualt in forum Gecko DrivesReplies: 11Last Post: 09-23-2003, 02:42 AM
Tags for this Thread
Posting Permissions
