[DSlezak]

I have been trying to diagnose our EZ-Trak at the shop here and all problems are pointing to the BMDC board. From reading this forum, there appears to be a utility to help confirm this, B3T.exe. I am unable to find this file anywhere on the machine or our installation floppies. If someone could assist me with obtaining this file, I would greatly appreciate it!

Thank you for your time!

[tpmx57]

I have the B3t.exe that is for a TC-22 mill,don,t know if its the same.
Looks like it detects BMDC3L,BMDC3 or BMDC4
If someone can confirm its the same file you need I can email it to you.

[DSlezak]

tpmx57,

Being that no one has responded yet -- Would you mind submitted the file anyways? BMDC3 sounds quite familiar, but I would have to pull the board to verify.

Thanks again.

[machintek]

B3T is only one version. The early boards ( BMDC in 2 axis EZTRAKs) do not identify themselves to the test but it can still be run.
Hard to transfer a exe file. Most firewalls stop it.

George

[DSlezak]

Thanks for the information machintek. To bypass the firewalls, you can easily zip the file before sending via email. Alternatively, if anyone can help, I can provide FTP information to assist in the transfer. Private message me for contact information on how to send the file.

Thanks!

[machintek]

Perhaps a Email address to send to?

George

[DSlezak]

You may send the file via email to dslezak at gmail.com

Thanks in advance!

[LopezRod]

Can anybody send me the file B3T.exe to lopez.cl.rodrigo at gmail.com?

I appreciate so much your help

Rodrigo