Got not one, but two 6030s with a gremlin.The offset value (fixture or tool) will, without anyone's help, place a < symbol where a decimal point was. There isn't even a key to enter that on the keyboard.Got a .25 hole in a fixture where there shouldn't be, because it will even happen while running. Anybody?
Thread: corrupt offset table
Results 1 to 3 of 3
-
10-07-2014, 05:43 PM #1
Registered
- Join Date
- Aug 2007
- Posts
- 29
corrupt offset table
-
10-21-2014, 03:27 PM #2
Registered
- Join Date
- Aug 2007
- Posts
- 29
Re: corrupt offset table
An update to this 'gremlin' is that the < symbol only appears (when it does) after the number '2'. It may leave some offsets containing a 2 alone, but others it will immediately follow. The decimal point is still there. Example - 2<.032. Any help ?
-
10-22-2014, 01:03 PM #3
Registered
- Join Date
- Jun 2008
- Posts
- 51
Re: corrupt offset table
Suggestions:
- Reinitializing the memory.
- Remove and re-seat the memory expansion board several times to clean the contact pins.
- Clean the processor board back plane pins with a pencil eraser.
Reply With QuoteSimilar Threads
-
Corrupt programs?
By Most in forum Haas MillsReplies: 18Last Post: 04-03-2014, 01:22 PM -
V23 corrupt
By FUBAR62172 in forum BobCad-CamReplies: 5Last Post: 04-16-2012, 03:08 AM -
corrupt files on 18i-mb
By ikennedy in forum FanucReplies: 0Last Post: 11-21-2011, 11:41 PM -
Corrupt Software
By ericwaa in forum MilltronicsReplies: 6Last Post: 10-08-2009, 10:30 PM -
WTH Corrupt fixture Offset!?
By DareBee in forum FadalReplies: 3Last Post: 07-15-2005, 03:11 PM
Tags for this Thread
Posting Permissions
