Rotations / movements in contour pockets

Hello!
I have a question about rotations / movements in contour pockets!
Is it possible to move islands in a contour pocket and repeat it there without programming of several islands???

Thanks in advance

Yes, it’s possible

Program the island with G91 in a subprogram.

Then you can move it with zero point movement ⇒ move or with TRANS.

And rotate with command ROT / AROT

click here

Thanks!
But is it also in ShopMill possible?

Yes, it also works in Shopmill

(from ver. 6.03)

or write in a G-clause:

N10 TRANS X100

Zero point will be moved in X at 100mm. it works in the same way for Y and Z.

TRANS (remove again)

Hello

If you programmed your contour and island, rotation or displacing causes rotation or movement of your contour pocket.
It’s impossible to rotate islands without contour rotation.
Aside from the alternative that you reprogram it.